Speco Technologies IP Camera (camera) Default Password & IP Address
Find the default username, password, and IP address for Speco Technologies IP Camera (camera). Access your Speco Technologies IP Camera (camera) admin panel with factory default credentials.
The default login for the Speco Technologies IP Camera (camera) is username "admin" and password "1234". If these credentials do not work, they were changed after setup — perform a factory reset to restore the defaults.
Default Credentials
1 Credentials| Username | Password | IP Address | Port | Protocol |
|---|---|---|---|---|
| admin | 1234 | - | 80 | HTTP |
Port Forwarding Guide
Want to open ports for your Speco Technologies IP Camera (camera)? Set up servers, cameras, and games easily.
Factory Reset Guide
Forgot your password? Learn how to factory reset your Speco Technologies IP Camera (camera) to restore default credentials.
How to Login to Speco Technologies IP Camera (camera)
Follow these steps to access the Speco Technologies IP Camera (camera) admin panel using the default credentials listed above.
- Make sure your computer or phone is connected to the Speco Technologies IP Camera (camera) network via Wi-Fi or Ethernet cable.
- Open a web browser (Chrome, Firefox, Safari, Edge) and enter the device IP address into the address bar.
- When the login screen appears, type the default username and password from the table above.
- If the credentials work, you will be taken to the Speco Technologies IP Camera (camera) admin dashboard. If they fail, the password may have been changed — perform a factory reset.
- For security reasons, change the default password immediately after your first successful login.
Common Login Problems & Fixes
Cannot reach the login page
Confirm you are connected to the correct network and that the IP address is correct. Try a different browser or clear your browser cache.
Default password not accepted
Someone may have changed the password. Perform a factory reset to restore the original Speco Technologies IP Camera (camera) credentials.
Page loads but admin panel never opens
Check that you typed http:// (not https://) and that no VPN or proxy is intercepting traffic to the local IP.
Forgot the changed password
Hold the reset button on the Speco Technologies IP Camera (camera) for 10–15 seconds to restore factory defaults, then use the table above.
Security Tips for Technologies IP Camera (camera)
IP cameras are a common attack target. After logging into your Speco Technologies IP Camera (camera), change the password, disable UPnP/peer-to-peer cloud features if not needed, and put the camera on an isolated VLAN or guest network.
Common ports for Speco Technologies IP Camera (camera)
RTSP · HTTP/HTTPS · mDNS · WS-DiscoveryIP cameras from Speco typically expose RTSP for video streaming plus an HTTP/HTTPS configuration interface, and announce themselves over mDNS and WS-Discovery. Keep them on an isolated VLAN where possible.
See full port reference →About Speco
Speco is a manufacturer of network and IT hardware. Default credentials shipped with Speco devices are publicly documented for setup and recovery purposes — that is why we maintain this database. After your first login you should always change the Speco Technologies IP Camera (camera) password to a strong, unique value.
Is Your Network Slow or Insecure?
Older modems and routers are vulnerable to cyberattacks and throttle your internet speed. Secure and accelerate your home network with a next-gen WiFi 6 Router from Amazon's bestsellers.
How to Reset Speco Technologies IP Camera (camera)
If the default credentials don't work, your device may have been configured with a custom password. To restore factory defaults:
- Locate the Reset button (usually a small pinhole on the back of the device)
- Press and hold the Reset button for 10-15 seconds using a paperclip
- Wait for the device to reboot (LEDs will flash)
- After the reset, use the default credentials from the table above to log in