Juniper (ssh) Default Password & IP Address
Find the default username, password, and IP address for Juniper (ssh). Access your Juniper (ssh) admin panel with factory default credentials.
Default Credentials
8 Credentials| Username | Password | IP Address | Port | Protocol |
|---|---|---|---|---|
| redline | redline | - | 22 | SSH |
| serial# | serial# | - | 22 | SSH |
| super | juniper123 | - | 22 | SSH |
| admin | peribit | - | 22 | SSH |
| admin | <<< %s(un=\'%s\') = %u. | - | 22 | SSH |
| admin | abc123 | - | 22 | SSH |
| admin | netscreen | - | 22 | SSH |
| netscreen | netscreen | - | 22 | SSH |
Port Forwarding Guide
Want to open ports for your Juniper (ssh)? Set up servers, cameras, and games easily.
Factory Reset Guide
Forgot your password? Learn how to factory reset your Juniper (ssh) to restore default credentials.
HARDWARE UPGRADE RECOMMENDED
Is Your Network Slow or Insecure?
Older modems and routers are vulnerable to cyberattacks and throttle your internet speed. Secure and accelerate your home network with a next-gen WiFi 6 Router from Amazon's bestsellers.
View WiFi 6 Routers on AmazonFree Shipping with Amazon Prime
How to Reset Juniper (ssh)
If the default credentials don't work, your device may have been configured with a custom password. To restore factory defaults:
- Locate the Reset button (usually a small pinhole on the back of the device)
- Press and hold the Reset button for 10-15 seconds using a paperclip
- Wait for the device to reboot (LEDs will flash)
- After the reset, use the default credentials from the table above to log in
Frequently Asked Questions
What is the default password for Juniper (ssh)?
Username: redline / Password: redline
How do I factory reset this device?
Locate the Reset button (usually a small pinhole on the back of the device). Press and hold the Reset button for 10-15 seconds using a paperclip. Wait for the device to reboot (LEDs will flash). After the reset, use the default credentials from the table above to log in.