Cisco-Arrowpoint Base Model Default Password & IP Address
Find the default username, password, and IP address for Cisco-Arrowpoint Base Model. Access your Cisco-Arrowpoint Base Model admin panel with factory default credentials.
Default Credentials
1 Credentials| Username | Password | IP Address | Port | Protocol |
|---|---|---|---|---|
| admin | system | 192.168.1.1 | 80 | HTTP |
Port Forwarding Guide
Want to open ports for your Cisco-Arrowpoint Base Model? Set up servers, cameras, and games easily.
Factory Reset Guide
Forgot your password? Learn how to factory reset your Cisco-Arrowpoint Base Model to restore default credentials.
How to Login to Cisco-Arrowpoint Base Model
Follow these steps to access the Cisco-Arrowpoint Base Model admin panel using the default credentials listed above.
- Make sure your computer or phone is connected to the Cisco-Arrowpoint Base Model network via Wi-Fi or Ethernet cable.
- Open a web browser (Chrome, Firefox, Safari, Edge) and enter the device IP address into the address bar.
- When the login screen appears, type the default username and password from the table above.
- If the credentials work, you will be taken to the Cisco-Arrowpoint Base Model admin dashboard. If they fail, the password may have been changed — perform a factory reset.
- For security reasons, change the default password immediately after your first successful login.
Common Login Problems & Fixes
Cannot reach the login page
Confirm you are connected to the correct network and that the IP address is correct. Try a different browser or clear your browser cache.
Default password not accepted
Someone may have changed the password. Perform a factory reset to restore the original Cisco-Arrowpoint Base Model credentials.
Page loads but admin panel never opens
Check that you typed http:// (not https://) and that no VPN or proxy is intercepting traffic to the local IP.
Forgot the changed password
Hold the reset button on the Cisco-Arrowpoint Base Model for 10–15 seconds to restore factory defaults, then use the table above.
Security Tips for Base Model
Default credentials make any device a target. After logging into your Cisco-Arrowpoint Base Model, change the password to something strong and unique, disable services you do not need, and keep firmware updated.
About Cisco-Arrowpoint
Cisco-Arrowpoint is a manufacturer of network and IT hardware. Default credentials shipped with Cisco-Arrowpoint devices are publicly documented for setup and recovery purposes — that is why we maintain this database. After your first login you should always change the Cisco-Arrowpoint Base Model password to a strong, unique value.
Is Your Network Slow or Insecure?
Older modems and routers are vulnerable to cyberattacks and throttle your internet speed. Secure and accelerate your home network with a next-gen WiFi 6 Router from Amazon's bestsellers.
How to Reset Cisco-Arrowpoint Base Model
If the default credentials don't work, your device may have been configured with a custom password. To restore factory defaults:
- Locate the Reset button (usually a small pinhole on the back of the device)
- Press and hold the Reset button for 10-15 seconds using a paperclip
- Wait for the device to reboot (LEDs will flash)
- After the reset, use the default credentials from the table above to log in